Table of Contents
Advertisement
Figure 27. Installing the compute node cover
Step 3.
Hold the front of the compute node and slide the cover forward to the closed position, until it
clicks into place.
After you install the compute node cover, install the compute node into the chassis (see "Installing a compute
node in a chassis" on page 105 for instructions).
Removing the air baffle
Use this information to remove the air baffle.
Before you remove the air baffle, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To remove the air baffle, complete the following steps:
Step 1.
Remove the cover (see "Removing the compute node cover" on page 113).
Step 2.
Grasp the air baffle, disengage pins from pin holes; then, lift the air baffle up.
116
Lenovo NeXtScale nx360 M5 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
