Table of Contents
Advertisement
Figure 16. UEFI boot backup jumper (JP2) location
Step 5.
Move the UEFI boot backup jumper (JP2) from pins 1 and 2 to pins 2 and 3 to enable the UEFI
recovery mode.
Step 6.
Reinstall the server cover; then, reconnect all power cords.
Step 7.
Restart the server. The system begins the power-on self-test (POST).
Step 8.
Boot the server to an operating system that is supported by the firmware update package that
you downloaded.
Step 9.
Perform the firmware update by following the instructions that are in the firmware update package
readme file.
Step 10. Turn off the server and disconnect all power cords and external cables, and then remove the cover
(see "Removing the compute node cover" on page 113).
Step 11. Move the UEFI boot backup jumper (JP2) from pins 2 and 3 back to the primary position (pins 1
and 2).
.
Chapter 3
Troubleshooting
81
Advertisement
Table of Contents
Troubleshooting
