Removing The Air Baffle - Lenovo BladeCenter HS23E Problem Determination And Service Manual

1. Orient the blade server with the cover side down and the bezel towards you.
2. Locate where you will be installing the blade handle.
3. Orient the blade handle so that the blue release latch is towards the middle of
4. Align the hole in the blade handle with the hole on the blade server where the
5. Use a screwdriver to install the screw that secures the blade handle to blade
6. Install the blade server into the BladeCenter unit (see "Installing the blade

Removing the air baffle

Use this information to remove the air baffle from the blade server.
The following illustration shows how to remove a air baffle from a blade server.
Note: The illustrations in this document might differ slightly from your hardware.
To remove the air baffle, complete the following steps.
58
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
Note: The left handle and right handle are not the same part. To identify where
the blade handle should be installed, see the illustration and parts listing
provided in Chapter 4, "Parts listing," on page 41.
the blade server.
handle will be installed.
server. It is recommended to install the screw that was removed when the
blade handle was removed.
server in a BladeCenter unit" on page 50).