Removing And Replacing Tier 1 Crus - Lenovo NeXtScale nx360 M5 Installation And Service Manual

Figure 53. Installing a hard disk drive cage (1.8-inch)
Step 1. Remove the cover (see "Removing the compute node cover" on page 113).
Step 2. Position the cage with an angle and rotate the cage into position on the system board.
Step 3. Align the cage with the screw holes on the planar tray.
Step 4. Using a Phillips (for 3.5-inch hard disk drive cage) or T8 torx (part number 00FK488, for 2.5-inch
or 1.8-inch hard disk drive cage, provided on the back of the chassis) screwdriver, insert the
screws (four for 3.5-inch hard disk drive cage and three for 2.5-inch or 1.8-inch hard disk drive
cage) and secure the cage in the compute node.
Step 5. Install the hard disk drive backplate if there is one (see "Installing the hard disk drive backplate" on
page 162).
Step 6. Insert the easy-swap hard disk drives or the solid-state drives (see "Removing and installing
drives" on page 164).
Step 7. For cable routing, see "Internal cable routing and connectors" on page 216.
After you install the hard disk drive cage, complete the following steps:
1. Install the cover onto the compute node (see "Installing the compute node cover" on page 115 for
instructions).
2. Install the compute node into the chassis (see "Installing a compute node in a chassis" on page 105
for instructions).

Removing and replacing Tier 1 CRUs

Replacement of Tier 1 CRUs is your responsibility. If Lenovo installs a Tier 1 CRU at your request, you will
be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
134
Lenovo NeXtScale nx360 M5 Installation and Service Guide