Hex screws
Figure 43. Hex screws installation
Step 7.
Reinstall the cover (see "Installing the compute node cover" on page 115).
Step 8.
Slide the compute node into the rack.
Step 9.
Reconnect the power cords and any cables that you removed.
Step 10. Turn on the peripheral devices and the compute node.
Removing the filler from the GPU tray
Use this information to remove the filler from the GPU tray.
Before you remove the filler from the GPU tray, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To remove the filler from the GPU tray, complete the following steps:
Step 1.
Remove the cover (see "Removing the compute node cover" on page 113).
Step 2.
Press on the touch point of the filler and lift the filler up.
126
Lenovo NeXtScale nx360 M5 Installation and Service Guide