Installing A 2U Gpu Tray Into A Compute Node - Lenovo NeXtScale nx360 M5 Installation And Service Manual

2
Figure 24. Removal of a 2U GPU tray
Step 4. Pull the 2U GPU tray out of the compute node.
If you are instructed to return the 2U GPU tray, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.

Installing a 2U GPU tray into a compute node

Use this information to install a 2U GPU tray in a NeXtScale nx360 M5 compute node.
Important: When you install the new 2U GPU tray, you must update the 2U GPU tray with the latest
firmware. Make sure that you have the latest firmware before you proceed. See "Updating the firmware" on
page 29 for more information.
Note: The 2U GPU tray supports only 1300-watt power supply unit with high-line Vin (AC 200 volt to 240 volt).
Before you install the compute node in a chassis, read "Safety" on page v and "Installation guidelines" on
page 101.
To install the 2U GPU tray to compute node, complete the following steps:
Step 1. Carefully lay the 2U GPU tray on a flat, static-protective surface, orienting the 2U GPU tray with the
release latch near your right hand side.
Step 2. Orient the 2U GPU tray so that the posts on the inside of the 2U GPU tray slide into the slots
on the compute node.
Note: Before you install the 2U GPU tray, make sure that the air baffles and all components are
installed and seated correctly and that you have not left loose tools or parts inside the compute
node.
112
Lenovo NeXtScale nx360 M5 Installation and Service Guide
1