Table of Contents
Advertisement
Figure 25. 2U GPU tray installation
Step 3.
Hold the front of the compute node and slide the 2U GPU tray forward to the closed position,
until it clicks into place.
Step 4.
Reinstall the PCI riser-cage assembly in the 2U GPU tray (see "Replacing a PCI riser-cage
assembly to the 2U GPU tray" on page 183).
Step 5.
Connect the cables that were disconnected from the 2U GPU tray.
Step 6.
Replace the cover (see "Installing the compute node cover" on page 115).
Removing and replacing structural parts
Use this information to remove and replace consumable and structural parts.
Replacement of structural parts is your responsibility. If Lenovo installs a structural part at your request,
you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing the compute node cover
Use this information to remove the cover from a compute node.
Before you remove the compute node cover, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
.
Chapter 5
Removing and replacing components
113
Advertisement
Table of Contents
Troubleshooting
