Lenovo NeXtScale nx360 M5 Installation And Service Manual page 20

Machine type 5465
Hide thumbs Also See for NeXtScale nx360 M5:
Table of Contents

Advertisement

• Supports 4 GB, 8 GB, 16 GB RDIMMs, and 32 GB LRDIMMs with up to 512 GB of total memory
on the system board
Integrated functions:
• Integrated management module 2.1 (IMM2.1), which consolidates multiple management functions
in a single chip
• Concurrent COM/VGA/2x USB (KVM)
• System error LEDs
• Two network ports (two 1 Gb Ethernet ports on the system)
• Supports up to one optional ML2 network adapter
• One optional System Management RJ-45 to connect to a systems management network. This system
management connector is dedicated to the integrated management module 2.1 (IMM2.1) functions
• (Optional) Hardware RAID supportability for RAID level-0, RAID level-1, RAID level-5, RAID level-6,
or RAID level-10
• Wake on LAN (WOL)
Drive expansion bays (depending on the model):
Supports up to eight 3.5-inch SATA (if the storage tray is installed, up to 7 in the storage tray and 1 in the
compute node), two 2.5-inch SATA/SAS, six 2.5-inch hot-swap SATA/SAS (while no PCIe adapter is
installed; if the 2U GPU tray is installed, up to 4 in the 2U GPU tray and 2 in the compute node), or four
1.8-inch solid-state drives (with signal 6 Gb only).
Attention: As a general consideration, do not mix standard 512-byte and advanced 4-KB format drives
in the same RAID array because it might lead to potential performance issues.
Table 1. Supported hard disk drives combinations
RAID adapter
HDD form
factor
Supported
HDD
configurations
in compute
node
Upgradeable firmware:
All firmware is field upgradeable.
PCI expansion slots (depending on your model):
• Compute node
– Front slot: PCI Express x16 (PCIe3.0, full-height, half-length)
– ML2 slot: PCI Express x16 (support 50 mm in height only)
– Rear slot: PCI Express x8 (PCIe3.0, full-height, half-length)
• GPU tray
– Two PCI Express x16 slots (PCIe3.0, full-height, full-length)
6
Lenovo NeXtScale nx360 M5 Installation and Service Guide
Front HDD
(hot-swap)
2.5-inch x 2
V
Rear RAID
adapter (x8
rear RAID
riser)
V
Onboard
SATA mode
(non RAID)
Rear HDD (simple-swap)
3.5-inch x 1
2.5-inch x 2
V
V
V
V
V
1.8-inch x 4
V
V

Advertisement

Table of Contents
loading

Table of Contents