Lenovo NeXtScale nx360 M5 Installation And Service Manual page 823

2. Check IBM support site for any applicable service bulletin or UEFI or adapter firmware update
that applies to this error. NOTE: It may be necessary to disable unused option ROMs from UEFI
F1 setup or ASU or using adapter manufacturer utilities so that adapter firmware can be updated.
3. Move the adapter to a different slot. If a slot is not available or error recurs, replace the adapter.
4. If the adapter was moved to a different slot and the error did not recur, verify that this is not a
system limitation. Then replace the system board. Also, if this is not the initial installation and the
error persists after adapter replacement, replace the system board.
• I.2018003 [I.2018003]
Explanation: A bad option ROM checksum was detected for the device found at Bus % Device %
Function %. The Vendor ID for the device is % and the Device ID is %. ROM CHECKSUM ERROR
Severity
Error
User Response
Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or
upgraded, reseat the adapter and any attached cables.
2. Move the adapter to a different system slot, if available.
3. Check IBM support site for any applicable service bulletin or UEFI or adapter firmware update
that applies to this error. NOTE: It may be necessary to configure slot to Gen1 or to use
special utility software so that adapter firmware can be upgraded. Gen1/Gen2 settings can be
configured via F1 Setup -> System Settings -> Devices and I/O Ports -> PCIe Gen1/Gen2/Gen3
Speed Selection, or the ASU Utility.
4. Replace the adapter.
• I.3808004 [I.3808004]
Explanation: The IMM System Event log (SEL) is full. IPMI System Event Log is Full
Severity
Info
User Response
Complete the following steps:
1. Use the IMM Web Interface to clear the event log.
2. If IMM communication is unavailable, use F1 Setup to access System Event Logs Menu and
Choose Clear IMM System Event Log and Restart Server.
• I.3818001 [I.3818001]
Explanation: The firmware image capsule signature for the currently booted flash bank is invalid. Current
Bank CRTM Capsule Update Signature Invalid
Severity
Info
User Response
Appendix B. UEFI (POST) error codes
809