Figure 44. Filler removal
Step 3.
Remove the filler from the GPU tray and set it aside.
Attention: For proper cooling and airflow, replace the filler before you turn on the compute node.
Operating the compute node with the filler removed might damage GPU tray components.
Replacing the filler on to the GPU tray
Use this information to install the filler on to the GPU tray.
Before you install the filler from the GPU tray, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To install the filler on to the GPU tray, complete the following steps:
Step 1.
Remove the cover (see "Removing the compute node cover" on page 113).
Step 2.
Align the filler with the bracket on the middle of the GPU tray; then, lower the filler into the GPU
tray. Press the filler down until it is securely seated.
Filler
.
Chapter 5
Removing and replacing components
127