Table of Contents
Advertisement
Figure 28. Air baffle removal (compute node)
Figure 29. Air baffle removal (GPU tray)
Step 3.
Remove the air baffle from the compute node/GPU tray and set it aside.
Attention: For proper cooling and airflow, replace the air baffle before you turn on the compute
node. Operating the compute node with the air baffle removed might damage compute node
components.
Replacing the air baffle
Use this information to install the air baffle.
Before you install the air baffle, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 101.
2. If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see "Removing a compute
node from a chassis" on page 104 for instructions).
3. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
To install the air baffle, complete the following steps:
Air baffle
Chapter 5
.
Removing and replacing components
117
Advertisement
Table of Contents
Troubleshooting
