Holder, Ffc, Cr Removal; Harness, Head, C Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
6. Remove the five "Holder, FFC" ("Holder, FFC; B").
(Refer to p325 and , p328.)
7. Remove the "Carriage Cover".
(Refer to "4.2.4.3 C593_SUB Board" (p234).)
8. While releasing the upper tab of the "Holeder, FFC, CR" (
"Holeder, FFC, CR" frontward to remove it (
9. Disconnect the "Harness, Head, C" from the connector on the "C593_SUB
Board". (Refer to Figure 4-177.)
When reassembling the "Holder, FFC, CR", match the
dowels with the positioning holes of the "Carriage Unit" and
install the "Holder, FFC, CR", then secure it with the tab.
Disassembly & Assembly
), slide the
). (Refer to Figure 4-177.)
Dowels
Positioning Holes
Disassembly Procedures
Tab
1
Figure 4-177. Holder, FFC, CR Removal
C593_SUB Board
Figure 4-178. Harness, Head, C Removal
Revision C
2
332