Epson Stylus Pro 4400 Service Manual page 171

EPSON Stylus Pro 4400/4450/4800/4880/4880C
PRINTER COVER OPEN
LCD
TOP COVER OPEN
RELEASING PAPER LEVER
LCD
LOAD PAPER (Except roll paper)
LOAD PAPER SUCTION
(Roll paper only)
Troubleshooting
Explanation
Generated when Printer Cover is open during one of the movements.
Under this error, all of CR motion and ink sequences are halted.
Therefore it may give damages to printing head if this situation
continues very long time.
Explanation
Paper Lever was released during standby.
Troubleshooting Based on Panel Messages
Recovery
Close the Printer Cover.
When cover was open during flushing before paper feed
movement, the flushing operation is interrupted, but after closing
the cover, the flushing and paper feed movement are completed.
When cover was open during paper eject,
(p.166)" occurs after clearing this error.
When cover was open during paper feed movement,
recognition error (p.167)" occurs after clearing this error.
When cover was open during paper cut movement,
(p.168)" occurs after clearing this error.
When cover was open while power was OFF, power will turn OFF
after capping printhead.
If error is not cleared after cover is closed, check operation of Self
Testing Menu Cover Sensor p.90 and perform steps below if not
normal.
Check that the cover is closed properly.
Replace the P Cover Open Sensor.(p.224)
Recovery
Pull down the Paper Lever.
Revision C
"Paper eject error
"Paper
"Paper cut error
171