EPSON Stylus Pro 4400/4450/4800/4880/4880C
SUPPORTED MAIN COMMAND AND SENDING TIMING
Table 1-51. Supported Main Command and Sending Timing
Main command
Command name
number
01h
Start Software Reset
04h
Send Name Data
07h
Inquire Software Emulation
Type
0Eh
Inquire ASCII Message
14h
Inquire Emergency Reply
15h
Send Emergency Message
SENDING BDC-ST CHARACTER STRINGS VIA DBIN-REGISTER
When ST of Type-B I/F sets "ON" State-Reply, BDC-ST is sent through DBIN-
register. When State Reply is started, "Start" and "End" of BDC-ST characters
are announced by sending the Main command (0Eh).
NOTE: The BDC-ST is only sent when Type-B Lv2 is used.
Product Description
Sending timing
Init signal on the std. parallel
Type B I/F Option command: 01h
Panel Reset
Cold start
Type B I/F Option command: 05h
Changing Software Emulation type
Writing to DBIN-register
Reply for Emergency command
Receive Emergency command
Interface
TYPE-B LEVEL 3 PACKET MODE
Communication between Type-B I/F card and Printer corresponds to Type-B
Level 3 (Packet Mode) Communication Specification. (IEEE P1284.4 (Draft
1.50) compliant)
Packet Mode Shifting
To shift to Type-B Level 3 Packet Mode, Option Card needs to correspond
to Type-B Level 3 ("D4" character string need to be added to Option Type
character string). If Option Card that is non-Type B Level 3
correspondence is inserted, Type-B sends error.
Supported Channel
Assigning Service and Channel applies the chart below.
Table 1-52. Supported Channel
Socket
Service
Use
ID
1284.4CTRL
00h
1284.4
control
EPSON-MIB
04h
SNMP/MIB
setting
EPSON-TRAP
05h
SNMP/
Trap
notification
EPSON DATA
40h
Send print
(Include Out of
data
Band)
Revision C
Max Data
Initiator
Credit
Size
—
64byte
1 (Limited Mode)
I/F Card
556byte
1 (Limited Mode)
Printer
556byte
1 (Limited Mode)
—
32kbyte
Depends on
(1 Packet)
received buffer
(Unlimited Mode)
109