Epson Stylus Pro 4400 Service Manual page 37

EPSON Stylus Pro 4400/4450/4800/4880/4880C
Note *1: Thick paper is not available.
*2: The status becomes no ink or maintenance tank full according to the
remaining amount of ink when cleaning is executed.
*3: It is assigned to key function in panel setting.
*4: Only available when the roll paper is loaded.
*5: It is lit for 100ms at 5 sec. intervals.
*6: Only shifting to printer status menu is available. (Pause LED blinks when
displaying menu)
*7: Blink indicator of maintenance tank.
*8: Blinks corresponding indicator.
*9: The message of reboot request is displayed when the rear sensor detects the
absence of paper after the user removes the paper.
*10: Initialization of mechanism (includes compulsory quit of cleaning) will not be
executed after panel reset execution but initialization of received data will be
executed.
*11: Initialization of mechanism (includes compulsory quit of cleaning) will not be
executed after panel reset execution but initialization of received data will be
executed only in no paper for ASF situation.
*12: Panel setting menu can be shifted in order to execute ink replace sequence
during ink out.
*13: Display by switching at 3-second intervals.
*14: It is displayed when printer cannot print the adjustment pattern, etc. It returns
to the display before performing after 3 seconds.
*15: Only using ASF, paper eject operation is performed by reset.
*16: A displayed unit is the [second]. It is displayed while counting down each 1
second from maximum time.
*17: After cut sheet error occurred, paper eject operation would be performed by
pressing down the Paper Feed Switch [⁄], and then it will occur ASF paper out
error after ejecting paper. When paper eject operation is completed, paper is
loaded from ASF by pressing down the Paper Feed Switch [Ÿ] / [⁄].
*18: Cut sheet is ejected automatically.
*19: In this case, printer status shifts pause status (LCD display too) and count
down is continued by releasing pause.
*20: To reduce nonsense calls when the carriage lock is unreleased, this message
is displayed for CR servo system service calls when initial ink charge FLG is
set.
Product Description
*21: displayed if remote ink commands differ from the ink type of this printer (8
color/ 4 color)
*22: Wrong ink error message is switched at 3 second-intervals.
*23: The remaining paper counter value is displayed when the remaining paper
detection is on. While the counter is suspended, it blinks.
*24: This is not occurred on the usual market, but added as another status for
maintenance work.
*25: The message indicating K ink replacement conformation is displayed after
Wrong PK/ MK is forcibly released.
*26: For 4-color model, [LOWER INK LEVER] is displayed because it is not
iequipped with the right and left levers.
Operating Panel
Revision C
37