"Stand" Setting - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
8. Hold the front panel section of the printer, lift the printer upward and keep it
there, and then set the "Stand" in both the rubber foot on the bottom of the
printer and the "Base, Left", following the steps below.
8-1. Fit the rubber foot of the printer into the foot receiver at the upper
end of the "Stand".
8-2. Fit the lower end of the "Stand" into the protrusion of the "Base,
Left". (Be sure that the concave portion of the "Stand" matches the
convex portion of the "Base, Left".)
9. Tilt the printer upward a little (the same amount of the spring stroke of the
left stand ) as holding the front panel section of the printer, and set the
"Stand" in both the rubber foot on the right bottom of the printer and the tab
of the "Base, Right", using the same steps in
Disassembly & Assembly
Step 8.
Disassembly Procedures
Step 8-1/Step 9
Step 8-2/Step 9
Figure 4-58. "Stand" Setting
Revision C
250