Screw Securing Gutter, Ink; Gutter, Ink Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
6. Remove the screw securing "Gutter, Ink".
(Refer to Figure 4-120.)
C.B. (P1) 3x4: 1 pc.
7. Remove "Gutter, Ink" by following the steps below.
7-1. Slide "Gutter, Ink" to left side.
7-2. Move "Gutter, Ink" right side downward.
7-3. Pull out "Gutter, Ink" left lower side toward you.
Make sure that "Push Spring, Absorbent Pad, Gutter" is
attached to "Gutter, Ink". If it has removed, install it as
shown in the figure below.
Push Spring, Absorbent Pad, Gutter
Assembly Catch
Disassembly & Assembly
(Refer to Figure 4-121.)
Assembly Catch
Disassembly Procedures
Figure 4-120. Screw Securing Gutter, Ink
3
Figure 4-121. Gutter, Ink Removal
Revision C
C.B. (P1) 3x4
Gutter, Ink
1
2
295