Screws Securing "Frame, Asf, Right"; "Frame, Asf, Right" Removal; "Wheel, Detector" Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
3. Remove the three screws that secure the "Frame, ASF, Right" from the
bottom of the "ASF Unit", and remove the "Frame, ASF, Right" from the
hole shown in Figure 4-64 as holding the "Hopper"
C.B.P. 3x8: 3 pcs.
When installing the "Frame, ASF, Right", make sure that both
the grooves of the "Cover, Roller, LD, Left" and the "Cover,
Roller, LD, Right" are engaged with the rail of the "Frame,
ASF, Lower".
4. Push down and release the tab that secures the "Wheel, Detector" using a
precision driver or a similar tool, and then remove the "Wheel, Detector".
(Refer to Figure 4-65.)
Figure 4-63. Screws Securing "Frame, ASF, Right"
Disassembly & Assembly
C.B.P. 3x8
Disassembly Procedures
Freme, ASF, Right
Figure 4-64. "Frame, ASF, Right" Removal
Wheel, Detector
Figure 4-65. "Wheel, Detector" Removal
Revision C
Hopper
255