P Thick Sensor (0.8/0.3); P Thick Sensors Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
4.2.9.4 P_THICK Sensor (0.8) / P_THICK Sensor (0.3)
1. Remove "Cover, Rear" (p223).
2. Remove "PT Sensor Unit". (Refer to "4.2.9.1 Release Unit" (p343).)
3. Disconnect connectors from "P_THICK Sensors".
4. Release the three tabs securing "P_THICK Sensor", and remove the
"P_THICK Sensors".
Be sure to refer to Chapter 5
A D J U S T M E N T
R E Q U I R E D
perform specified adjustments after replacing or installing a
"P_THICK Sensor".
Disassembly & Assembly
"Adjustment" (p.366) and
Disassembly Procedures
Tabs
Connector
P_THICK Sensor (0.8) P_THICK Sensor (0.3)
Figure 4-212. P_THICK Sensors Removal
Revision C
Connector
351