Remaining Paper Display Setting; Unit Switching; Cutting Pressure; Panel Setting Initialization - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
PANEL DISPLAY LANGUAGE SELECTION
Users can select English, French, Italian, German, Spanish, and Portuguese
for display on the LCD with this mode.

REMAINING PAPER DISPLAY SETTING

This mode allows users to set the remaining paper detection to OFF/ roll paper
ON/ cut sheet ON. When the remaining paper detection is set to OFF, it is not
displayed in the printer setting menu. When the remaining paper detection is
set to roll paper ON/ cut sheet OFF, it is displayed.
NOTE: Roll paper and cut sheet cannot be set to ON simultaneously.

UNIT SWITCHING

Users can change length unit of LCD panel / pattern print with this mode.
METER : meter (m)
FEET/INCH : Feet (ft)/Inch (in)
Unit of following messages can be changed;
Table 1-37. Swithable Messages
Item
Panel LCD display Paper counter
Remainig paper menu
Job information display (Paper
used)
Nozzle check Job information display (Paper
pattern used)
Current Paper Count
Prev Paper Count
Status sheet Use Paper
Job information
Paper Used (vertical)
print
Note : This function is available only for English.
Product Description

CUTTING PRESSURE

Changes cutting pressure, which is set in the printer.
Adjustment value (calculated by spring balance / input value) in the process is
set to 100% (printer default), input / setting range by the user is set to between
0% ~ 150%.
The value entered by this function is worked as absolute value of printer,
• Remote SN m1 = 81h
• Panel setting "User paper setting"
multiplied to the value specified above.
SUPERSONIC CLEANING (SSCL)
Users can execute supersonic cleaning using this mode. If the number of times
that this cleaning is performed exceedes 250 times
CL3 instead.
Note *: This number will be reset by executing "Reset when printhead change" after
PAPER FEED SETTING
This mode allows users to set a certain amount of paper not to be fed when
turning the printer on with cutter setting OFF, and this reduces waste of paper.
Message
NOTE: When paper feed setting is set to on, the image will be printed on
Meter Feet/Inch
xxm xxft
xx.xm xxxft

PANEL SETTING INITIALIZATION

xxxxx.xcm xxxxft xxin
Users can change all setting values of panel setting mode to the default values
2
xxxxxxxcm xxxxxx.xsqft
or the factory setting values.
xxxxx.xcm xxxxft xxin
xxxxx.xcm xxxxft xxin
xxxxxx.xcm xxxxft xxin
xxxxxx.xcm xxxxft xxin
Operating Panel
replacing printhead.
the platen. Users have to change the setting at their own
responsibility.
Printer Setting Menu :Turns default setting back
User Paper Setting :Deletes the setting record
Gap Adjustment Menu :Turns default setting back
Maintenance Menu :Date setting is set back to absolute time
controlled by RTC power
Printer Status Menu :Deletes all information
Revision C
*
, however, the printer runs
87