Installation Plate, Detector, Rear Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
4.2.9.6 Rear Manual Insertion Sensor
1. Remove "Holder, Roller, Unit" (p214).
2. Remove "Paper Guide Assy., M, SP" (p215).
3. Release "Rear Manual Insertion Sensor" harness from the two tabs.
(Refer to Figure 4-216.)
4. Release "Guide, Roll Paper" along with "Rear Manual Insertion Sensor".
(Refer to "4.2.9.1 Release Unit" (p343).)
5. Remove the screw securing "Installation Plate, Detector, Rear" and
remove "Installation Plate, Detector, Rear".
(Refer to Figure 4-217.)
C.B.P. 3x8: 1 pc.
Align the two dowels of holder with the two frame
positioning holes.
Do not let the harness slip in "Installation Plate,
Detector, Rear".
Disassembly & Assembly
(Refer to Figure 4-217.)
(Refer to Figure 4-216.)
Disassembly Procedures
Harness Installation Plate, Detector, Rear
Tabs
Figure 4-216. Releasing the Harness
C.B.P. 3x8
Dowels and Installation Holes
Figure 4-217. Installation Plate, Detector, Rear Removal
Revision C
354