Screws Securing The Paper Eject Unit; Paper Eject Unit Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
4.2.9.2 Paper Eject Unit
1. Remove "Panel, Front/Panel Unit" (p219).
When performing the following steps, be careful not to take
C A U T I O N
hold of the Star Wheels of the "Paper Eject Unit".
2. Turn the "Paper Eject Unit" until the screws that secure the "Paper Eject
Unit" on both sides face forward, and remove the two screws.
(Refer to Figure 4-205.)
C.B.S. (P2) 3x6: 2 pcs.
3. Turn the "Paper Eject Unit" until the Star Wheel faces toward you.
(Refer to Figure 4-206.)
4. While avoiding interference with the "Holder, Eject Roller, Right", pull out
the "Paper Eject Unit" toward the front right side from the "Holder, Eject
Roller, Left". (Refer to Figure 4-206.)
Align the "Paper Eject Unit" dowel and "Holder, Eject Roller,
Left" positioning hole.
Disassembly & Assembly
(Refer to Figure 4-205.)
Disassembly Procedures
C.B.S. (P2) 3x6
Dowel and
Positioning Hole
Holder, Eject Roller, Left
Figure 4-205. Screws Securing the Paper Eject Unit
Step 3
Figure 4-206. Paper Eject Unit Removal
Revision C
Paper Eject Unit
C.B.S. (P2) 3x6
Holder, Eject Roller, Right
Step 4
348