Fan, Blower; Paper Guide, Eject, Stacker Removal; Releasing Relay Harness - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

4.2.5.2 Fan, Blower

1. Remove the four screws securing the two "Paper Guide, Eject, Stacker"s
and then remove the two "Paper Guide, Eject, Stacker"s.
(Refer to Figure 4-51.)
Installation Plate, Shaft, CR: 2 pcs.
C.B.S. 3x8:
2. Release relay harness connected to "Fan, Blower" (right) from acetate
tapes and clamp. (Refer to Figure 4-52.)
3. Disconnect the two rellay connectors as shown in
(Refer to Figure 4-52.)
Insert the two tabs of the "Paper Guide, Eject, Stacker" into
the two positioning holes on the "Frame, Fan, Unit".
Disassembly & Assembly
2 pcs.
Figure 4-52.
Frame, Fan, Unit
Positioning Holes
Tabs
Disassembly Procedures
C.B.S. 3x8
Installation Plate, Shaft, CR Paper Guide, Eject, Stacker
Figure 4-51. Paper Guide, Eject, Stacker Removal
Relay Connectors
Acetate Tapes (x3)
Figure 4-52. Releasing Relay Harness
Revision C
244