Cleaning Setting For Nozzle Check; Super Low Speed Cut Mode; Level Structure Of Cleaning Setting For Nozzle Check Menu; Level Structure Of Super Low Speed Cut Mode Menu - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

1.4.4.16 Cleaning Setting for Nozzle Check

Nozzle check method is switched to either auto or manual.
When "Cleaning setting at nozzle check" (=printer setting menu/auto cleaning)
is set to ON, auto nozzle check pattern printing is performed. When the
cleaning setting is set to OFF, manual nozzle check pattern printing is
executed.
The following shows the operations performed by each setting in "Cleaning
setting for nozzle check" and "Auto cleaning for each job".
Table 1-29. Operation setting
Cleaning
Auto cleaning
setting for
for each job
nozzle check
OFF OFF
ON OFF
OFF ON
ON ON
Note *: The command that is sent from the printer driver to the printer in order to
control the nozzle check.

Level structure of cleaning setting for nozzle check menu

PRINTER SETUP
AUTO CLEANING
[<]
Product Description
Auto nozzle Nozzle check
Nozzle check
check operation
operation by
operation when sending
panel
before Job "NC" m1 = 80h*
Manual None
Auto None
Manual None
Auto Execute
[< / >]
AUTO CLEANING
ON
[∧ / ∨]
AUTO CLEANING
OFF
[∧ / ∨]

1.4.4.17 Super Low Speed Cut Mode

When this setting is set to "ON", normal cut operation is performed at 20CPS to
reduce a noise and paper dust. The default is set to OFF.
However when top edge is cut at Top/Bottom borderless printing
setting,(including top margin at 1 cut setting.)this setting is not reflected to
prevent irregular color by reducing cut speed.

Level structure of super low speed cut mode menu

Manual
Auto
Manual
Auto
Operating Panel
[< / >]
PRINTER SETUP
QUIET CUT QUIET CUT
OFF
[∧ / ∨]
QUIET CUT
[<]
[∧ / ∨]
Revision C
ON
57