Paper Eject Phase Sensor Removal; Paper Eject Release Sensor Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
4.2.9.7 Paper Eject Phase Sensor
1. Pull out "I/H Left Unit" from printer.
(Refer to "4.2.8.4 I/H Left Unit / I/H Lever Sensor (Left)" (p296).)
2. Release the two tabs securing "Paper Eject Phase Sensor" and remove
"Paper Eject Phase Sensor".
3. Disconnect the connector from "Paper Eject Phase Sensor".
Confirm that acetate tape securing the "Paper Eject Phase
Sensor" harness does not cover the hole of the frame.
4.2.9.8 Paper Eject Release Sensor
1. Pull out "I/H Right Unit" from printer.
(Refer to "4.2.8.5 I/H Right Unit / I/H Lever Sensor (Right)" (p305).)
2. Release the two tabs securing "Paper Eject Release Sensor" and remove
"Paper Eject Release Sensor".
3. Disconnect the connector from "Paper Eject Release Sensor".
Disassembly & Assembly
Paper Eject Phase Sensor
Acetate tape should
not cover this hole
Acetate Tape
Figure 4-220. Paper Eject Phase Sensor Removal
Connector
Figure 4-221. Paper Eject Release Sensor Removal
Disassembly Procedures
Tabs
Connector
Tabs
Paper Eject Release Sensor
Revision C
356