Motor Assy., Pg Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
7. Remove the two screws securing "Motor Assy., PG".
(Refer to Figure 4-91.)
C.C. 3x6: 2 pcs.
When performing the following steps, be careful not to
C A U T I O N
scratch the frame with "Motor Assy., PG" pinion gear.
8. Seen from the right side of the printer, slide the "Motor Assy., PG" through
the upper right relief hole and then remove the "Motor Assy., PG" inward
while passing the pinion gear through the relief hole.
(Refer to Figure 4-91.)
Install "PG Motor" with the circuit board facing downward.
Be sure to refer to Chapter 5
A D J U S T M E N T
R E Q U I R E D
perform specified adjustments after replacing the "Motor
Assy., PG".
Disassembly & Assembly
Circuit Board
"Adjustment" (p.366) and
Disassembly Procedures
Relief Hole
1
Pinion Gear
Figure 4-91. Motor Assy., PG Removal
Revision C
PG Motor
2
C.C. 3x6
275