"Bushing, Lock, 11.4" Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
5. Rotate the "Bushing, Lock, 11.4" to the direction shown in
match the rib with the frame hole, release the boss at the lower part from
the frame, and then remove the "Bushing, Lock, 11.4" from the "Shaft,
Roller, LD". (The "Ground Spring, ASF" will be released at the same time.)
When installing the "Ground Spring, ASF", install the
"Bushing, Lock, 11.4" first, insert the both ends of the
"Ground Spring, ASF" into the right and left holes on the
bottom of the "Bushing, Lock, 11.4", and then hitch the other
side of the "Ground Spring, 11.4" to the tab located on the
bottom of the "Bushing, Lock, 11.4".
Bushing, Lock, 11.4
Ground Spring, ASF
Disassembly & Assembly
Figure 4-66 to
Tab
3
Disassembly Procedures
Bushing, Lock, 11.4
2
Figure 4-66. "Bushing, Lock, 11.4" Removal
Revision C
Rib Hole
1
256