Releasing Tension Of Belt, Motor, Pf; Motor Assy., Pf Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
6. Release "Motor Assy., PF" harness from clamp shown in
(Refer to Figure 4-210.)
7. Release "Extension Spring, 13.05" from "Plate, Motor, PF" hook and frame
hook. (Refer to Figure 4-210.)
8. Loosen the screw securing "Plate, Motor, PF" and release tension of "Belt,
Motor, PF". (Refer to Figure 4-210.)
C.B.S. (P2) 3x6: 1 pc.
When performing the following steps, pay attention to the
C A U T I O N
followings:
Be careful not to scratch the pinion gear of the "Motor
Assy., PF"
Be careful not to deform or damage the "Scale, PF"
attached to the "Pulley, Roller, PF".
9. Remove the two screws securing the "Motor Assy., PF".
(Refer to Figure 4-211.)
C.C. 3x6: 2 pcs.
10. Remove timing belt from pinion gear, pull pinion gear out through hole of
frame and then remove "Motor Assy., PF".
Be sure to refer to Chapter 5
A D J U S T M E N T
R E Q U I R E D
perform specified adjustments after installing or replacing
the "Motor Assy., PF".
Disassembly & Assembly
Figure 4-210.
(Refer to Figure 4-211.)
"Adjustment" (p.366) and
Disassembly Procedures
C.B.S. (P2) 3x6
Hooks
Clamp
Figure 4-210. Releasing Tension of Belt, Motor, PF
Motor Assy., PF
C.C. 3x6
Figure 4-211. Motor Assy., PF Removal
Revision C
Scale, PF
Belt, Motor, PF
Extension Spring, 13.05
Pinion Gear
350