Solenoid, Cr; "Solenoid, Cr" Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

4.2.7.11 Solenoid, CR

1. Remove "Carriage Unit" (p266).
2. Attach the "CUTTER CAP" to the cutter section of the "Carriage Unit".
(Refer to Figure 4-110.)
The "Cutter Cover", which covers the cutter blade projecting
C H E C K
upward from the bottom of the Carriage, prevents injury
P O I N T
during the work.
3. Release the harnesses of the "Solenoid, CR" from the tabs of the "Carriage
Unit". (Refer to Figure 4-105.)
4. Remove the screw and the plain washer that secure the "Solenoid, CR",
and then remove the "Solenoid, CR" from the "Carriage Unit".
C.B.P.(P2) 3x8 (+ plain washer 4.3x0.8x8): 1 pc.
Route the harnesses of the "Solenoid, CR" on the "Carriage
Unit" properly as shown in
Be sure to refer to Chapter 5
A D J U S T M E N T
R E Q U I R E D
perform specified adjustments after replacing the "Solenoid,
CR".
Disassembly & Assembly
Figure 4-105.
"Adjustment" (p.366) and
Disassembly Procedures
CUTTER CAP
Solenoid, CR
C.B.P.(P2) 3x8 Tab
+washer 4.3x0.8.8
Figure 4-105. "Solenoid, CR" Removal
Revision C
Tabs
284