Danfoss VLT FC 100 Operating Instructions Manual page 96

VLT HVAC Drive High Power Operating In-
structions
Parameter
Par. 0-01 Language
Motor Power [kW]
Par. 1-20
Motor Power [HP]
Par. 1-21
Par. 1-22 Motor Voltage *
Motor Frequency
Par. 1-23
Motor Current
Par. 1-24
Par. 1-25 Motor Nominal Speed
Motor Rotation Check
Par. 1-28
Par. 3-41 Ramp 1 Ramp Up Time
Ramp 1 Ramp Down Time
Par. 3-42
Motor Speed Low Limit [RPM] [RPM]
Par. 4-11
Par. 4-12 Motor Speed Low Limit [Hz] * [Hz]
Motor Speed High Limit
Par. 4-13
[RPM]
Motor Speed High Limit [Hz] * [Hz]
Par. 4-14
Par. 3-19 Jog Speed [RPM]
Jog Speed [Hz] *
Par. 3-11
Terminal 27 Digital Input
Par. 5-12
Par. 5-40 Function Relay **
Table 6.2: Quick Setup parameters
*The display showing depends on choices made in par. 0-02
Speed Unit and par. 0-03 Regional Settings . The default settings of
Motor Speed Unit and par. 0-03 Regional Settings depend on
par. 0-02
which region of the world the frequency converter is supplied to but
can be re-programmed as required.
** Par. 5-40 Function Relay , is an array, where one may choose be-
tween Relay1 [0] or Relay2 [1]. Standard setting is Relay1 [0] with the
default choice Alarm [9].
See the parameter description in the section
ters .
For a detailed information about settings and programming, please see
the VLT HVAC Drive Programming Guide, MG.11.CX.YY
x=version number
y=language
NB!
If [No Operation] is selected in par. 5-12
Digital Input , no connection to +24V on terminal 27
is necessary to enable start.
If [Coast Inverse] (factory default value) is selected
Terminal 27 Digital Input , a connection
in par. 5-12
to +24V is necessary to enable start.
[Units]
[kW]
[HP]
[V]
[Hz]
[A]
[RPM]
[Hz]
[s]
[s]
[RPM]
[RPM]
[Hz]
Motor
Commonly Used Parame-
Terminal 27
MG.11.F3.02 - VLT ® is a registered Danfoss trademark
6 How to Programme
6
95