Danfoss VLT FC 100 Operating Instructions Manual page 94

VLT HVAC Drive High Power Operating In-
structions
Group Title
25** Cascade Controller
26** Analog I/O Option MCB 109 Parameters used to configure the Analog I/O option (MCB 109) including: definition of the analog in-
Table 6.1: Parameter Groups
Parameter descriptions and selections are displayed on the graphic (GLCP) or numeric (NLCP) display. (See relevant section for details.) Access the
parameters by pressing the [Quick Menu] or [Main Menu] button on the control panel. The Quick Menu is used primarily for commissioning the unit at
start-up by providing the parameters necessary to start operation. The Main Menu provides access to all parameters for detailed application program-
ming.
All digital input/output and analog input/output terminals are multifunctional. All terminals have factory default functions suitable for the majority of
HVAC applications but if other special functions are required, they must be programmed as explained in parameter group 5 or 6.
Function
Parameters used to configure and monitor the built in pump cascade controller (typically used for
pump booster sets).
put types (e.g. voltage, Pt1000 or Ni1000) and scaling and definition of the analog output functions
and scaling.
MG.11.F3.02 - VLT ® is a registered Danfoss trademark
6 How to Programme
6
93