Danfoss VLT FC 100 Operating Instructions Manual page 133

6 How to Programme
6.1.9 Changing a Group of Numeric Data Values
If the chosen parameter represents a numeric data value, change the
chosen data value by means of the [◄] and [►] navigation keys as well
▲ ▼
as the up/down [ ] [ ] navigation keys. Use the ◄] and [►] navigation
keys to move the cursor horizontally.
113 RPM
Load depen. setting
1 - 60 Low speed load
100%
Illustration 6.5: Display example.
6
6.1.10 Changing of Data Value, Step-by-Step
Certain parameters can be changed step by step or infinitely variably.
This applies to par. 1-20
and par. 1-23 Motor Frequency .
6.1.11 Read-out and Programming of Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Par. 15-30 Alarm Log: Error Code to par. 15-32 Alarm Log: Time con-
tain a fault log which can be read out. Choose a parameter, press [OK],
and use the up/down navigation keys to scroll through the value log.
Use par. 3-10 Preset Reference as another example:
Choose the parameter, press [OK], and use the up/down navigation
keys keys to scroll through the indexed values. To change the parame-
ter value, select the indexed value and press [OK]. Change the value by
using the up/down keys. Press [OK] to accept the new setting. Press
[Cancel] to abort. Press [Back] to leave the parameter.
132
1.78 A
compensation
Motor Power [kW] , par. 1-22 Motor Voltage
MG.11.F3.02 - VLT
VLT HVAC Drive High Power Operating In-
Use the up/down navigation keys to change the data value. The up key
enlarges the data value, and the down key reduces the data value.
Place the cursor on the value to be saved and press [OK].
1(1)
1- 6*
Illustration 6.6: Display example.
The parameters are changed both as a group of numeric data values
and as numeric data values infinitely variably.
® is a registered Danfoss trademark
729RPM 6.21A
Load depen. setting
1 - 60 Low speed load
compensation
1 0% 6
structions
1(1)
1- 6*