Danfoss VLT FC 100 Operating Instructions Manual page 131

6 How to Programme
22-77 Minimum Run Time
Range:
0 s* [ 0 - par. 22-76 s]
Does not work in cascade mode.
6.1.5 Main Menu Mode
Both the GLCP and NLCP provide access to the main menu mode. Se-
lect the Main Menu mode by pressing the [Main Menu] key. Illustration
6.2 shows the resulting read-out, which appears on the display of the
6
GLCP.
Lines 2 through 5 on the display show a list of parameter groups which
can be chosen by toggling the up and down buttons.
1107 RPM
Main menu
0 - ** Operation/Display
1 - ** Load/Motor
2 - ** Brakes
3 - ** Reference / Ramps
Illustration 6.2: Display example.
6.1.6 Parameter Selection
In the Main Menu mode, the parameters are divided into groups. Select
a parameter group by means of the navigation keys.
The following parameter groups are accessible:
130
Function:
Sets the time desired as minimum run time after a normal start command (Start/Jog/Freeze). Any
normal stop command will be disregarded until the set time has expired. The timer will start
counting following a normal start command (Start/Jog/Freeze).
The timer will be overridden by a Coast (Inverse) or an External Interlock command.
Each parameter has a name and number which remain the same re-
gardless of the programming mode. In the Main Menu mode, the pa-
rameters are divided into groups. The first digit of the parameter num-
ber (from the left) indicates the parameter group number.
All parameters can be changed in the Main Menu. The configuration of
the unit (par. 1-00
ters available for programming. For example, selecting Closed Loop en-
ables additional parameters related to closed loop operation. Option
3.84 A 1 (1)
cards added to the unit enable additional parameters associated with
the option device.
MG.11.F3.02 - VLT ® is a registered Danfoss trademark
VLT HVAC Drive High Power Operating In-
Configuration Mode ) will determine other parame-
structions