Iq5 Low Image Density Rap; Iq6 Black Or Dark Image Rap - Xerox B210 Service Manual

IQ5 Low Image Density RAP

The printed image is light, with no ghosting,
Initial Actions
Remove Toner Cartridge. Rotate the cartridge 5-6 full rotations to redistribute the toner. Make a
test print.
Check the life of the Toner Cartridge, refer to
tridge if it has reached end of life.
If the problems continue, follow the procedure.
Procedure
• Switch off the machine.
• Clean the contacts on the Print Cartridge and the HVPS PWB.
• Switch on the power, then make a test print.
The problem continues.
Y N
Perform SCP 04, Final Actions.
Install a new HVPS PWB, PL 4.1 Item 2.
Figure 1 Light Image
Image Quality
IQ5, IQ6
Figure 1.
GP 2, Machine Reports. Install a new Toner Car-

IQ6 Black or Dark Image RAP

The printed image is totally dark or black,
Procedure
Do not perform repair activities with the power on or electrical power supplied to the
machine. Some machine components contain dangerous electrical voltages that can
result in electrical shock and possible serious injury.
DANGER: Ne pas effectuer de dépannnage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine. Certains éléments de la machine compor-
tent des tensions électriques dangereuses qui peuvent causer un choc électrique et de
graves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con l'alimentazione elettrica inserita.
Alcuni componenti contengono corrente ad alta tensione che può provocare forti
scosse e gravi ferite.
VORSICHT: Es dürfen erst Reparaturarbeiten durchgeführt werden, wenn das Gerät aus-
geschaltet ist oder der Netzstecker nicht mehr mit der Stromquelle verbunden ist. Einige
Komponenten des Gerätes sind stromführend und können daher zu ernsthaften Verlet-
zungen oder Stromschlägen führen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente.
Algunos componentes de la máquina contienen voltajes eléctricos peligrosos que
pueden producir una descarga eléctrica y causar daños graves.
• Switch off the machine.
• Clean the contacts on the Toner Cartridge, Drum Cartridge, and the HVPS PWB,
Item 2.
• Switch on the power, then make a test print.
The problem continues.
Y N
Perform SCP 04, Final Actions.
• If the image is Black, install a new HVPS PWB,
make a test print.
July 2019
3-6
Figure 1.
WARNING
PL 4.1 Item 2, switch on the power, then
Initial Release
Xerox® B210 Service Manual
PL 4.1