Removing The Dadf Solenoid Unit - Canon i-SENSYS MF229dw Service Manual

4
Disassembly/Assembly > Original Exposure/Feed System (DADF Model) > Removing the DADF Solenoid Unit > Procedure

Removing the DADF Solenoid Unit

■ Preparation
1) Remove the Left Cover (Duplex Model) (Refer to page 4-86).
2) Remove the DADF Unit + Reader Unit (Refer to page 4-27).
3) Disconnecting the DADF Unit + Reader Unit (Refer to page 4-30).
4) Removing the DADF Pickup Unit (Refer to page 4-32).
5) Remove the DADF Motor Unit (Refer to page 4-36).
■ Procedure
CAUTION:
Be sure to perform work carefully so as to displace the gear phase.
4 Disassembly/Assembly > Original Exposure/Feed System (DADF Model) > Removing the DADF Solenoid Unit > Procedure
F-4-70
1) Remove the DADF Solenoid Unit [1].
• 1 E-ring [2]
• 2 Screws [3]
• 3 Harness Bands [4]
[1]
2x
[3]
NOTE: How to assemble the DADF Solenoid Unit
• Pass the Solenoid Shaft [1] through the hole [A] of the Solenoid Arm.
• Ensure that the 2 points on the DADF Pickup Unit Shaft [2] and the 2 contact points [B]
on the DADF Solenoid Unit are in contact with each other.
[B] [1]
4-38
[2]
[4]
F-4-71
[A] [2]
F-4-72
4-38