Upgrading Via Internet - Canon i-SENSYS MF229dw Service Manual

Upgrading via Internet

■ Overview
The firmware of the host machine can be upgraded via Internet without using PC by selecting
"Via Internet" in the operation panel .
Menu > System Management Settings > Update Firmware > Via Internet
MEMO :
• Refer to the User's Manual of the device for how to connect the device to the external
network.
• This is applicable either in a wired LAN environment or a wireless LAN environment.
■ Preparation
1) Check that there are no other jobs being executed.
2) In an environment where access is obtained via a proxy server, the proxy setting is made
from the Remote UI.
Settings/Registration > System Management Settings > Network Settings >
TCP/IP Settings > Proxy Settings > Edit... > Use Proxy(select)
Select the [Use Proxy] check box and specify the required settings.
3) Check that the serial number of the host machine is shown on the Main Controller PCB.
MEMO :
To upgrade the firmware of the host machine via Internet, the serial number of the
machine need to be written on the Main Controller PCB.
Execute COPIER > FUNCTION > MISC-P> SPEC, and check that the BODY No. is
registered.
If the BODY No. has not been registered, register the serial number according to "Service
Mode > COPIER > OPTION > SERIAL" in "Replacing main controller PCBs".
6
Trouble Shooting > Version Upgrade > Upgrading via Internet > Messages
6 Trouble Shooting > Version Upgrade > Upgrading via Internet > Messages
■ Messages
The message displayed on the device LUI is as follows.
No. Error message The timing of
occurrence
1 Job in progress... If there is a job
Wait a moment, then try again. being executed:
2 Cannot check the firmware Network error
version.
(Server communication error.)
3 Cannot download the firmware.
(Error during download.)
4 ***DOWNLOAD MODE*** If update (writing)
NETWORK AVAILABLE of the firmware
IP ADRESS has ended in
IP address of the machine failure:
PRESS STOP KEY TO EXIT
5 ***DOWNLOAD MODE***
FAILED TO UPDATE
6 ***DOWNLOAD MODE*** If the update of
UPDATE IS COMPLETE the firmware is
successful
6-13
Remedy
1. Wait until the job is completed.
2. Cancel the job.
1. Check whether the device can be
connected to the external network.
2. Check whether the proxy setting has
been made (in case of access via a
proxy server).
1. Check whether the device can be
connected to the external network.
2. Check whether the proxy setting has
been made (in case of access via a
proxy server).
3. Check that the serial number of the
host machine is shown on the Main
Controller PCB.
1. Update the firmware again using
UST.
-
T-6-18
6-13