4
Disassembly/Assembly > Original Exposure/Feed System (SADF Model) > Removing the Flat Bed Motor Unit (SADF Model) > Preparation
CAUTION:
If the Contact Image Sensor Unit comes off, be sure to put the tooth [1] of the belt in the
groove [2] on the bottom of the Contact Image Sensor to install the unit.
[2]
[1]
4
Disassembly/Assembly > Original Exposure/Feed System (SADF Model) > Removing the Flat Bed Motor Unit (SADF Model) > Preparation
Removing the Flat Bed Motor Unit (SADF Model)
■ Preparation
● Duplex Model
1) Remove the Left Cover (Duplex Model) (Refer to page 4-86).
2) Remove the SADF Unit + Reader Unit (Refer to page 4-51).
3) Separate the SADF Unit and the Reader Unit (Refer to page 4-54).
4) Remove the Copyboard Glass (SADF Model) (Refer to page 4-68).
F-4-176
● Sinplex Model
1) Remove the Left Cover (Sinplex Model)(Refer to page 4-144).
2) Remove the SADF Unit + Reader Unit (Refer to page 4-51).
3) Separate the SADF Unit and the Reader Unit (Refer to page 4-54).
4) Remove the Copyboard Glass (SADF Model) (Refer to page 4-68).
4-72
F-4-177
4-72