Preparing For Installation; This Chapter Describes The Site Requirements For Installing The Cisco Ubr 3X10 Rf Switch. The Chapter; Contains The Following Sections; Warning Only Trained And Qualified Personnel Should Be Allowed To Install, Replace, Or Service This Equipment - Cisco uBR-3x10 Hardware Installation And Cabling Manual
Rf switch
Table of Contents
Advertisement
Safety, page 2-2
•
Site Requirements, page 2-5
•
Provisioning the Headend, page 2-7
•
Tools for Installation, page 2-9
•
Verifying the Shipping Container Contents, page 2-11
•
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Warning
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
C H A P T E R
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
2
2-1
Advertisement
Chapters
Table of Contents
