Appendix; Unsupported Commands In Cisco Ios Release 12.2(44)Se; Access Control Lists; Unsupported Privileged Exec Commands - Cisco WS-C3020 Software Configuration Manual

Unsupported Commands in
Cisco IOS Release 12.2(44)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the switch prompt but are not supported in this release, either because they are not
tested or because of switch hardware limitations. This is not a complete list. The unsupported commands
are listed by software feature and command mode.

Access Control Lists

Unsupported Privileged EXEC Commands

access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
show access-lists rate-limit [destination]
show accounting
show ip accounting [checkpoint] [output-packets | access violations]
show ip cache [prefix-mask] [type number]

Unsupported Global Configuration Commands

access-list rate-limit acl-index {precedence | mask prec-mask}
access-list dynamic extended

Unsupported Route-Map Configuration Command

match ip address prefix-list prefix-list-name [prefix-list-name...]
OL-8915-03
A P P E N D I X
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
C
C-1