Ruckus Wireless ZoneDirector 1100 User Manual page 92

Enabling Network Management Systems
Configuring SNMP Support
Figure 45. Enabling the SNMPv2 agent
If your network uses SNMPv3
To enable SNMPv3 management:
1 Go to Configure > System. Scroll down to the bottom of the page and click
the Network Management link to open the Network Management section.
2 Under the SNMPv3 Agent section, select the Enable SNMP Agent check box.
3 Enter the following information for both the Read Only and Read-Write privileges:
• User: Enter a user name between 1 and 31 characters.
• Authentication: Choose MD5 or SHA authentication method (default is
MD5).
MD5: Message-Digest algorithm 5, message hash function with 128-bit
-
output.
SHA: Secure Hash Algorithm, message hash function with 160-bit output.
-
• Auth Pass Phrase: Enter a passphrase between 8 and 32 characters in
length.
• Privacy: Choose DES, AES or None.
- DES: Data Encryption Standard, data block cipher.
- AES: Advanced Encryption Standard, data block cipher.
- None: No Privacy passphrase is required.
92
Ruckus Wireless, Inc.