Ruckus Wireless ZoneDirector 1100 User Manual page 66

Enabling Smart Redundancy
Configuring ZoneDirector for Smart Redundancy
2 Go to Configure > System, and set a static IP address under Device IP Settings,
if not already configured.
3 Click Apply. You will need to log in again using the new IP address (if changed).
4 On the same Configure > System page, locate the Smart Redundancy section.
Figure 28. Enable Smart Redundancy
5 Enable the check box next to Enable Smart Redundancy.
6 Enter the IP address of the backup unit under Peer Device IP Address (if
known). If you have configured Limited ZD Discovery under Configure > Access
Points > Access Point Policies, you must identify the IP address of both
ZoneDirectors that the APs should connect to when Smart Redundancy is active.
If the Limited ZD Discovery and Smart Redundancy information you enter is
inconsistent, a warning message will be displayed asking you to confirm. Note
that Ruckus recommends using the Smart Redundancy feature instead of the
Limited ZD Discovery feature whenever possible.
7 Enter a Shared Secret for two-way communication between the two
ZoneDirectors (up to 15 alphanumeric characters).
8 Click Apply to save your changes and prompt ZoneDirector to immediately
attempt to discover its peer on the network.
9 If discovery is successful, the details of the peer device will be displayed to the
right.
66
Ruckus Wireless, Inc.