Ruckus Wireless ZoneDirector 1100 User Manual page 237

5 Deselect the check box next to Enable to disable this LAN port entirely. All ports
are enabled by default.
6 Select DHCP_Opt82 if you want to enable this option for this port (see
Option
7 For any enabled ports, you can choose whether the port will be used as a Trunk
Port, an Access Port or a General Port. The following restrictions apply:
• All APs must be configured with at least one Trunk Port.
• For single port APs (e.g., ZoneFlex R300), the single LAN port must be a
trunk port and is therefore not configurable.
• For ZoneFlex 7025/7055, the LAN5/Uplink port on the rear of the AP is
defined as a Trunk Port and is not configurable. The four front-facing LAN
ports are configurable.
• For all other APs, you can configure each port individually as either a Trunk
Port, Access Port or General Port. (See
more information.)
8 (If Smart Mesh is not enabled), choose whether this port will serve as an 802.1X
Authenticator or Supplicant, or leave 802.1X settings disabled (default). (See
Using Port-Based 802.1X
9 Click Apply to save your changes.
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
82").
for more information.)
Working with Access Point Groups
Modifying Model Specific Controls
Designating Ethernet Port Type
"DHCP
for
237