Ruckus Wireless ZoneDirector 1100 User Manual page 318

Creating a Guest Access Service
Configuring Guest Subnet Access
You can create up to 22 subnet access rules, which will be enforced both on the
ZoneDirector side (for tunneled/redirect traffic) and the AP side (for local-bridging
traffic).
To create a guest access rule for a subnet:
1 Go to Configure > Guest Access.
2 Edit or create a new Guest Access Service.
3 Scroll down to the bottom and expand the Restricted Subnet Access section.
4 Click Create New to create a new subnet restriction. Text boxes appear under
the table columns in which you can enter parameters that define the access rule.
5 Under Description, type a name or description for the access rule that you are
creating.
6 Under Type, select Deny if this rule will prevent guest users from accessing
certain subnets, or select Allow if this rule will allow them access.
7 Under Destination Address, type the IP address and subnet mask (format:
A.B.C.D/M) on which you want to allow or deny users access.
8 If you want to allow or restrict subnet access based on the application, protocol,
or destination port used, click the Advanced Options link, and then configure
the settings.
9 Click OK to save the subnet access rule.
Repeat Steps 4 to 9 to create up to 22 subnet access rules.
318
Ruckus Wireless, Inc.