Ruckus Wireless ZoneDirector 1100 User Manual page 256

Managing Access Points Individually
Using Limited ZD Discovery for N+1 Redundancy
- Netmask
- Gateway
- Primary DNS Server
- Secondary DNS Server
16 If Smart Mesh is enabled (see
the Advanced Options section lets you define the role this AP should play in
the mesh network--Auto, Root AP, Mesh AP, or Disable (default is Auto). In most
cases, Ruckus Wireless recommends leaving this setting on Auto to reduce the
risk of isolating a Mesh AP. Select Disable if you do not want this AP to be part
of your mesh network.
17 If this AP is a Mesh AP and you want to manually set which APs can serve as
its uplinks, select the Manual radio button under Advanced Options > Uplink
Selection (default is Smart). The other APs in the mesh appear below the
selection.
18 Select the check box next to each AP that you want to allow the current AP to
use as an uplink.
NOTE: If you set Uplink Selection for an AP to Manual and the uplink AP that you
selected is off or unavailable, the AP status on the Monitor > Access Points page
will appear as Isolated Mesh AP. See
information.
Figure 132. Manual uplink selection for APs in a mesh
19 If you select Override Group Config in the Port Setting section, a new section
opens where you can customize the Ethernet port behavior for this AP. Enabling
this will override the AP Group settings made on
256
"Deploying a Wireless Mesh via
Troubleshooting Isolated Mesh APs
Configuring AP Ethernet
ZoneDirector"),
for more
Ports.
Ruckus Wireless, Inc.