Ruckus Wireless ZoneDirector 1100 User Manual page 249

Prefer Primary ZD: Enable this option if you want APs to revert to the
-
primary ZoneDirector's control after connection to the primary controller
is restored.
Keep AP's Primary and Secondary ZD Settings: Enable this option if
-
you want the AP's existing settings to take precedence (not be overwritten
by secondary controller's settings after failover to secondary ZD).
• Management VLAN: You can enable the ZoneDirector management VLAN
if you want to separate management traffic from regular network traffic. The
following options are available:
- Keep AP's setting: Click this option if you want to preserve the Manage-
ment VLAN settings as configured on the AP. Note that Management
VLAN on the AP is disabled by default.
VLAN ID: Enter a valid VLAN ID to segment management traffic into the
-
VLAN specified. Valid VLAN IDs are 1-4094.
NOTE: If you change the Management VLAN ID here, you also need to set the
Management VLAN ID that ZoneDirector needs to use on the Configure > System
Settings page. Otherwise, ZoneDirector and the APs will be unable to communicate
via the Management VLAN.
• Load Balancing: Balances the number of clients across adjacent APs (see
Load
• Tunnel MTU: Use this field to set the Maximum Transmission Unit for tunnel
packets between ZoneDirector and APs. The MTU is the size of the largest
protocol data unit (in bytes) that can be passed. Supported MTU values range
from 850 to 1500 (default is 1500). Note that changing this setting to a value
less than 1280 will affect IPv6 connectivity.
• Auto Recovery: Set an AP auto recovery time in minutes, after which APs
will reboot in attempt to reconnect to ZoneDirector. Default is 30 minutes.
3 Click Apply to save and apply your settings.
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
Balancing).
Reviewing Current Access Point Policies
Viewing AP Ethernet Port Status
249