Ruckus Wireless ZoneDirector 1100 User Manual page 350

Deploying a Wireless Mesh via ZoneDirector
Step 2: Enable Mesh Capability on ZoneDirector
Figure 188. Enable Mesh in Configure > Mesh
To enable mesh capability:
1 Log into the ZoneDirector web interface.
2 Click the Configure tab.
3 On the menu, click Mesh.
4 Under Mesh Settings, select the Enable Mesh check box.
NOTE: You cannot disable Smart Mesh once you enable it. This is by design, to
prevent isolating nodes. If you want to disable Smart Mesh once it has been enabled,
you will have to factory reset ZoneDirector, or disable mesh for each AP, as described
in Managing Access Points
5 In Mesh Name (ESSID), type a name for the mesh network. Alternatively, do
nothing to accept the default mesh name that ZoneDirector has generated.
6 In Mesh Passphrase, type a passphrase that contains at least 12 characters.
This passphrase will be used by ZoneDirector to secure the traffic between Mesh
APs. Alternatively, click Generate to generate a random passphrase with 32
characters or more.
350
Individually.
Ruckus Wireless, Inc.