Ruckus Wireless ZoneDirector 1100 User Manual page 67

10 If discovery is unsuccessful, you will be prompted to retry discovery or continue
configuring the current ZoneDirector.
11 Install the second ZoneDirector and complete the Setup Wizard.
12 Go to Configure > System, enable Smart Redundancy and enter the primary
ZoneDirector's IP address in Peer Device IP address.
13 Click Apply. If an active ZoneDirector is discovered, the second ZoneDirector
will assume the standby state. If an active device is not discovered, you will be
prompted to retry discovery or to continue configuring the current device.
Once Smart Redundancy has been enabled, a status link is displayed at the top of
the web interface.
Figure 29. Smart Redundancy status link
NOTE: If you want to use the same SSL certificate for both devices in a Smart
Redundancy pair, you can back up the certificate/private key from one device and
import it into the other. See
NOTE: If you have two ZoneDirectors of the same model and license level, Ruckus
Wireless recommends using the Smart Redundancy feature. If you have two
ZoneDirectors of different models or different license levels, you can use Limited ZD
Discovery to provide limited redundancy; however, this method does not provide
synchronization of the user database.
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
Working with SSL Certificatesfor more information.
Enabling Smart Redundancy
Configuring ZoneDirector for Smart Redundancy
67