Label
Reset
USB
Console
10/100/1000 Ethernet
Front Panel LEDs
Table 4
describes the LEDs on the front panel of ZoneDirector 3000.
Table 4.
ZoneDirector 3000 LED descriptions
LED Label
Power
Status
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
Meaning
To restart ZoneDirector, press the Reset button
once for less than two seconds.
For Ruckus Wireless Support use only
RJ-45 port for accessing the ZoneDirector
command line interface.
Two auto negotiating 10/100/1000Mbps
Ethernet ports. For information on what the two
Ethernet LEDs indicate, refer to
State
Meaning
Green
ZoneDirector is receiving power.
Off
ZoneDirector is NOT receiving power. If
the power cable or adapter is
connected to a power source, verify
that the power cable is connected
properly to the power jack on the rear
panel of ZoneDirector.
Solid Green
Normal state.
Flashing Green
ZoneDirector has not yet been
configured. Log into the web interface,
and then configure ZoneDirector using
the setup wizard.
Solid Red
ZoneDirector has shut down (but is still
connected to a power source).
Flashing Red
ZoneDirector is starting up or shutting
down.
ZoneDirector Physical Features
ZoneDirector 3000
Table
4.
23