Ruckus Wireless ZoneDirector 1100 User Manual page 236

Working with Access Point Groups
Modifying Model Specific Controls
NOTE: For the internal heater to be operational, ZoneFlex 7762 APs must be
powered by the supplied PoE injector and its associated power adapter or a
standard 802.3at PSE. For the PoE Out port to be operational, ZoneFlex 7762 APs
must be powered by the supplied PoE injector and its associated power adapter.
• PoE Out Ports: Enable PoE out ports (specific ZoneFlex AP models only).
NOTE: If your ZoneDirector country code is set to United Kingdom, an additional
"Enable 5.8 GHz Channels" option will be available for outdoor 11n APs. Enabling
this option allows the use of restricted C-band channels. These channels are
disabled by default and should only be enabled by customers with a valid license
to operate on these restricted channels.
• Disable Status LEDs: When managed by ZoneDirector, you can disable the
external LEDs on certain ZoneFlex models, such as the 7300 series APs. This
can be useful if your APs are installed in a public location and you don't want to
draw attention to them.
• External Antenna: External antenna configuration is available for the 5 GHz radio
on the ZoneFlex 7762, and for the 2.4 and 5 GHz radios on the 7782-E APs.
Once enabled, enter a gain value in the range of 0 to 90dBi.
• Radio Band: (ZoneFlex 7321 only) Select 2.4 GHz or 5 GHz radio band for the
7321 APs.
• Port Settings: See
Configuring AP Ethernet Ports
You can use AP groups to control Ethernet ports on all APs of a certain model.
Then, if you want to override the port settings for a specific AP, you can do so as
explained in the
To configure Ethernet ports for all APs of the same model:
1 Go to Configure > Access Points.
2 In Access Point Groups, click Edit next to the group you want to configure.
3 Locate the Model Specific Control section, and select the AP model that you
want to configure from the list.
4 In Port Setting, select Override System Default. The screen changes to display
the Ethernet ports on the AP model currently selected.
236
"Configuring AP Ethernet
Managing Access Points Individually
Ports".
section below.
Ruckus Wireless, Inc.