Ruckus Wireless ZoneDirector 1100 User Manual page 91

Both SNMPv2 and SNMPv3 can be enabled at the same time. The SNMPv3
framework provides backward compatibility for SNMPv1 and SNMPv2c manage-
ment applications so that existing management applications can still be used to
manage ZoneDirector with SNMPv3 enabled.
NOTE: For a list of the MIB variables that you can get and set using SNMP, check
the related SNMP documentation on the Ruckus Wireless Support Web site at
http://support.ruckuswireless.com/documents.
If your network uses SNMPv2
To enable SNMPv2 management:
1 Go to Configure > System. Scroll down to the bottom of the page and click
the Network Management link to open the Network Management section.
2 Under the SNMPv2 Agent section, select the Enable SNMP Agent check box.
3 Enter the following information:
• In SNMP RO community (required), set the read-only community string.
Applications that send SNMP Get-Requests to ZoneDirector (to retrieve
information) will need to send this string along with the request before they
will be allowed access. The default value is public.
• In SNMP RW community (required), set the read-write community string.
Applications that send SNMP Set-Requests to ZoneDirector (to set certain
SNMP MIB variables) will need to send this string along with the request
before they will be allowed access. The default value is private.
• In System Contact, type your email address (optional).
• In System Location, type the location of the ZoneDirector device (optional).
4 Click Apply to save your changes.
ZoneDirector 9.8 User Guide, 800-70599-001 Rev B
Enabling Network Management Systems
Configuring SNMP Support
91